Honeywell Water Heater Pilot Will Not Light

The system kept coming back with 4 flashes.

Honeywell water heater pilot will not light.

The control valve is the box located by the access cover. It s free for you to use and amazon pays a small commission https amzn to 33i9exy in this vid. It is located near the bottom of the tank. Pilot light issues are some of the most common problems experienced with gas water heaters.

I first tried resetting the module by turning it to off and re start the pilot light by turning the dial to pilot holding down pilot and push the spark igniter. Red status light doesn t blink status light code label. If you don t see a spark at all when you are trying to light your pilot it may be that you are not looking in at the right angle. Use my amazon link to shop.

You have to put your ear down to the floor to see the pilot. There are several possible reasons why the status light may not be blinking. Please read the safety information in the owner s manual and the labels on the water heater before attempting any of these procedures. When the water heater pilot light goes out first try relighting it following the directions on the water heater label.

I ve replaced thermocouple before on my old water heater with manual type valve but the pilot would always light and when i released the button to adjust burner setting it would go out. Although a blocked gas line is one reason why the pilot light on a rheem water heater won t light or stay lit there are other reasons as well some easier to correct than others. The pilot is not lit air in the gas line the thermopile is not hot enough. If the pilot doesn t relight if it goes out right after lighting or if the pilot light keeps going out by far the most common.

Without it the water heater won t be able to maintain internal temperatures allowing the water to cool off. Except when it s not working. Based on the status light code it means temperature exceeded. A faulty thermocouple or malfunction of the gas valve could be the culprit but the problem may be as simple as a draft coming from a crack in the wall or under the door.

Want to say thanks for the video. When i lit it manually this time the pilot was very week and i was thinking the thermopile was not getting hot enough low millivolts to operated the electronics. If you smell gas do not attempt to light the heater. If the smell does not dissipate replace the heater s control valve before proceeding.

Remove the pilot light access cover. The air intake is located on the bottom or side of the water heater and may need to be cleaned out in order for the pilot to stay lit.