1 what you will need when felting a shed roof.
How much should roofing felt overlap.
Can t wait to begin the roofing.
2 the process of felting a shed roof.
Metal sealing and fastening apply side lap sealant if the pitch of your roof is 2 12 or less.
Position this strip so that it overhangs the top of the first sheet by 75mm.
Roll out the first layer of felt.
Using a downwards brushing motion firmly press the top layer of roofing felt onto the adhesive taking care to.
The roofing felt should be applied in layers that overlap.
If this felt is either incorrectly situated i e.
Tack and secure the felt.
After this lines should be snapped every 34 as you move up the roof.
Chalk lines should be snapped 33 5 8 above the eave line.
Roofing felt is required to overlap 2 inches over the lower felt course.
The vertical leg of the drip edge should be at least 1 5 inches wide and extend at least 0 25 inches below the sheathing.
The last layer should go over both sides of the roof overlapping both side covered in felt.
Do the other side of the roof the same way also with an overlap at the peak.
Adjacent pieces of drip edge should overlap at least 2 inches 51 mm.
As the heat can partially melt the felt paper and the underside.
Add new felt layers.
Have a helper ready to assist with this step and take care to get the lines straight and clean.
The short overlap of the four inch offset is somewhat easier allowing you to use cutouts to overlap every two courses making less work for you.
Therefore a 2 inch overlap provides redundancy at the edges where the barrier is weakest.
Where the sheets overlap apply roofing sheet adhesive using a disposable brush.
Must be installed at the rakes and eaves of the roof.
Trapped behind the guttering or if it is badly weathered it needs to be replaced.
Work up the roof to the peak and fold felt over the top overlapping at least 3 inches and fasten it on both sides.
Clean and prepare the roof.
Take your second length of felt.
The overlapping felt creates a secondary barrier for moisture and wicks water away from the shingles above and the sheathing below.
When laying the metal panels on the roof the overlap ridge of the new panel should straddle the underlap ridge of the panel before it.
For an apex roof start at the bottom and lay it horizontal the next should overlap as in video so the water runs over the join as it runs off the roof finishing at the apex or top of roof.
Allow for felt overhang.
Nail along the top of this strip at 500mm.
The bottom course of felt on a roof called sarking felt ensures that all of the rainwater is correctly channeled into the gutter by protecting the eaves from any wind driven rain.
