How To Attach A Wooden Awning To A House

A small awning will generally not have these problems.

How to attach a wooden awning to a house.

Remove the shingles or siding in the area identified for the header board. Calculate the sightline clearance height about 6 feet 2 inches in this case. Retractable or fixed a lateral arm retractable awning will allow you to extend your awning without needing extra supports. These awnings only need one attachment to the house on the wall.

This awning from primrose is just the job available from primrose. Awnings need approximately 6 to 12 inches of open heightwise wall or roof space to be installed. Larger patio awnings may require permits or permission from the zoning board. This renders the siding vulnerable to moisture and voids the warranty even if you seal the hole.

Attach the ledger with 1 2 inch diameter lag screws or bolts every 16 inches or as specified by local building codes. There are at least three alternative ways to do it. Re check for level and then drill lag screw or bolt pilot holes through the ledger and into the house s framing. Http www primrose awnings co uk for a review three year.

If you want to hang something from your vinyl siding don t even think about drilling through it to attach a hook to the sheathing. Determine the beam size. Choose a roof pitch 3 12 and roof structure 2x6. They are in essence oversized swatches of water resistant fabric connected to a frame and attached to your house or some other structure.

They are made out of vinyl canvas or solution dyed acrylic. Work from the view back not from the house out. I cut one end of each 10 rafter with a 2 12 pitch cut 9 46 degrees and attached it to the 2x4 ledger with 2 galvanized wood screws. 8 inches in this case.

Need some shade in your garden. Wall space needed for attaching. Once the rafters were in place and secured to the 2x4 ledger and the 4x6 beam i measured from the house along the top of one of the end rafters and made a mark at 9 9.